For camera without motorized visor.

For camera without motorized visor.

DC-AC inverter for powering of 230 V appliances from 48 V supply (for.ex. battery). Input voltage 37,2 - 68 V. Output voltage 230 V / 50 Hz. Output power: max. 3000 VA. Overload and overheating protection. Communication by VE.Direct. Bluetooth is built-in - configure alarms, alarm relay, voltage cut-off, output voltage, frequency, eco-mode and more, all from within VictronConnect.

For camera with motorized visor.

For camera with motorized visor.

For camera with motorized visor.

Touchscreen with HD picture qiality. Connect up to total 4 cameras. On screen all camera can be shown at time. Sunshield, brackets and remote are included.

HD quality provides significantly sharper and clearer picture.

Touchscreen with HD picture qiality. Connect up to total 4 cameras. On screen one camera can be shown at time. Sunshield, brackets and remote are included.

HD quality provides significantly sharper and clearer picture.

Touchscreen with HD picture qiality. Connect up to total 4 cameras. On screen one camera can be shown at time. Sunshield, brackets and remote are included.

HD quality provides significantly sharper and clearer picture.

HD quality camera for better picture quality. Automatic heating below 10°C and IR sensor for night vision.

0

0

Holder for wireless remote control 584949.

Ordered separately:
Remote control: Art. no. 584949

Webasto Isolator / Spacer Set (Pack of 4)
Rubber spacers mounts on the heat exchanger, to ensure correct placement of the outer cover and to make sure assembly is level. Isolator set provides the correct distance between the outside of the burner chamber and the heater case to allow proper airflow through the heater. Spacers also reduce a risk of vibration.

Suitable for the following Webasto Heaters:

Webasto Air Top 2000ST
Webasto Air Top EVO 3900
Webasto Air Top EVO 5500

Victron Energy MK2 interface module to connect PC to Phoenix. For use with v18 software and Phoenix chargers only.

The MK2.2 and MK3 provide a galvanically isolated connection to VE.Bus, and it translates the VE.Bus protocol into the “MK2/MK3 Protocol”

The MK3-USB C allows the following products to connect to a computer for configuration and firmware updates:

Multi, MultiGrid, MultiPlus, MultiPlus-II, Quattro, Inverter / Charger settings in ECOmulti, EasySolar, EasyPlus, and Inverters with a VE.Bus communication port.

DC-AC inverter for powering of 230 V appliances from 48 V supply (for.ex. battery). Input voltage 37,2 - 68 V. Output voltage 230 V / 50 Hz. Output power: max. 5000 VA. Overload and overheating protection. Communication by VE.Direct. Bluetooth is built-in - configure alarms, alarm relay, voltage cut-off, output voltage, frequency, eco-mode and more, all from within VictronConnect.